Gemini GEM-P801 Installation Instructions Manual

Also see for GEM-P801: Datasheet

Gemini GEM-P801 Installation Instructions Manual Manual pdf 5 page image

5Programming the PanelRefer to GEM-P801 Programming Instructions (WI1090)Defaulting the Panel1. Remove power from the panel.2. Remove all wiring from terminal 19 (PGM) andterminal 3.3. Connect terminal 19 (PGM) to terminal 3.4. Apply power to the GEM-P801 control panel.5. After a few seconds the ARMED, READY andHSYSTEM TROUBLE LEDs will flash.6. The keypad will beep 3 times indicating thepanel default values have been loaded.7. Remove wiring between terminal 19 (PGM)and terminal 3.8. Re-install original wiring for terminal 19 (PGM)and terminal 3.Keypad ProgrammingRefer to WI1090 for information on keypadprogramming.DownloadingThe GEM-P801 panel can be download/uploadedwith PCD-Windows Version 4.1 software usingthe Ring Method, Answering Machine Override(Second Call) or A6 method ofdownloading. The panel can also beautomatically downloaded/uploaded using thePCPreset utilty. For Site Initiated Downloaded,see Auto Download ID Number [93].Local DownloadingWire as shown in Figure 1. Use the power up orA6 method of establishing a connection.The power up method is recommended if the panel isattempting to report.Remote DownloadingWire as shown in Figure 2. The panel can beremotely download/uploaded using any oneof the following methods:1. The A6 method2. Call-in method3. Answering Machine Override (SecondCall)4. Site-Initiated (PCPreset & A6 )5. Automatic Downloading (Using PCPreset)NOTE:Any programming in Dealer Options 1 [96] and DealerOptions 2 [97] will not be defaulted. If Dealer CodeLockout has been programmed the panel will not defaultthe Dealer Code.MODEMJ1TO COMPUTERJ3LOCALTOPCI2000J2TO EXTERNALMODEMJ4TELCOJ5 LINEOUT TOTELCOFIGURE 2 R EMOTE D OWNLOADGEM-P801 Panel at the siteRJ31XTELCO JACK16 17 18 19 20*GREEN*REDFIGURE 1 L OCAL D OWNLOADGND+PWRBLACKREDTELCOJACKMODEMPCL2000B*Insulate if not used