89NOTE:• A mirroring group can contain multiple source ports.• On the S3100V2-52TP switch, each port, serving as a unidirectional or bidirectional source port, can beadded to up to two mirroring groups.Configuring source CPUs for the local mirroring groupFollow these steps to configure source CPUs for a local mirroring group:To do… Use the command… RemarksEnter system view system-view —Configure source CPUsmirroring-group group-idmirroring-cpu slot slot-number-list{ both | inbound | outbound }RequiredBy default, no source CPU is configuredfor a local mirroring group.NOTE:A mirroring group can contain multiple source CPUs.Configuring the monitor port for the local mirroring groupYou can configure the monitor port for a mirroring group in system view, or assign the current port to amirroring group as the monitor port in interface view. The two methods lead to the same result.Configuring the monitor port in system viewFollow these steps to configure the monitor port of a local mirroring group in system view:To do… Use the command… RemarksEnter system view system-view —Configure the monitor port mirroring-group group-idmonitor-port monitor-port-idRequiredBy default, no monitor port is configuredfor a local mirroring group.Configuring the monitor port in interface viewFollow these steps to configure the monitor port of a local mirroring group in interface view:To do… Use the command… RemarksEnter system view system-view —Enter interface view interface interface-typeinterface-number —Configure the current port asthe monitor port[ mirroring-group group-id ]monitor-portRequiredBy default, a port does not serve as themonitor port for any local mirroring group.