141NQA entry (admin admin, tag test) history record(s):Index Response Status Time1 62 Succeeded 2011-01-10 10:49:37.3FTP test configuration exampleNetwork requirementsAs shown in Figure 45, configure NQA FTP tests to test the connection with a specific FTP server and thetime required for Device A to upload a file to the FTP server. The login username is admin, the loginpassword is systemtest, and the file to be transferred to the FTP server is config.txt.Figure 45 Network diagramConfiguration procedureNOTE:Before you make the configuration, make sure the devices can reach each other.# Create an FTP test group. system-view[DeviceA] nqa entry admin test[DeviceA-nqa-admin-test] type ftp# Specify the IP address of the FTP server 10.2.2.2 as the destination IP address for FTP tests.[DeviceA-nqa-admin-test-ftp] destination ip 10.2.2.2# Specify 10.1.1.1 as the source IP address for probe packets.[DeviceA-nqa-admin-test-ftp] source ip 10.1.1.1# Set the FTP username to admin, and password to systemtest.[DeviceA-nqa-admin-test-ftp] username admin[DeviceA-nqa-admin-test-ftp] password systemtest# Configure the device to upload file config.txt to the FTP server for each probe operation.[DeviceA-nqa-admin-test-ftp] operation put[DeviceA-nqa-admin-test-ftp] filename config.txt# Enable the saving of history records.[DeviceA-nqa-admin-test-ftp] history-record enable[DeviceA-nqa-admin-test-ftp] quit# Start FTP tests.[DeviceA] nqa schedule admin test start-time now lifetime forever# Stop the FTP tests after a period of time.[DeviceA] undo nqa schedule admin test# Display the results of the last FTP test.[DeviceA] display nqa result admin test