43To do… Use the command… RemarksConfigure the output rules ofthe system informationinfo-center source { module-name| default } channel{ channel-number |channel-name } [ debug { levelseverity | state state } * | log{ level severity | state state } * |trap { level severity | state state }* ] *OptionalSee “Default output rules of systeminformation.”Specify the source IP addressfor the log informationinfo-center loghost sourceinterface-type interface-numberOptionalBy default, the source interface isdetermined by the matched route, and theprimary IP address of this interface is thesource IP address of the log information.Configure the format of thetime stamp for systeminformation output to the loghostinfo-center timestamp loghost{ date | iso | no-year-date |none }Optionaldate by default.Set the format of the systeminformation sent to a log hostto UNICOMinfo-center format unicom OptionalH3C by default.Specify a log host andconfigure the related outputparametersinfo-center loghost{ host-ipv4-address | ipv6host-ipv6-address } [ portport-number ] [ channel{ channel-number |channel-name } | facilitylocal-number ] *RequiredBy default, the system does not outputinformation to a log host. If you specify tooutput system information to a log host,the system uses channel 2 (loghost) bydefault.The value of the port-number argumentshould be the same as the valueconfigured on the log host, otherwise, thelog host cannot receive systeminformation.Outputting system information to the trap bufferNOTE:The trap buffer receives the trap information only, and it discards the log and debugging information evenif you have configured to output them to the trap buffer.To do… Use the command… RemarksEnter system view system-view —Enable information center info-center enable OptionalEnabled by defaultName the channel with aspecified channel numberinfo-center channel channel-numbername channel-nameOptionalSee Table 2 for default channel names.
