143# Configure HTTP tests to visit website /index.htm.[DeviceA-nqa-admin-test-http] url /index.htm# Configure the HTTP version 1.0 to be used in HTTP tests. (Version 1.0 is the default version, and this stepis optional.)[DeviceA-nqa-admin-test-http] http-version v1.0# Enable the saving of history records.[DeviceA-nqa-admin-test-http] history-record enable[DeviceA-nqa-admin-test-http] quit# Start HTTP tests.[DeviceA] nqa schedule admin test start-time now lifetime forever# Stop HTTP tests after a period of time.[DeviceA] undo nqa schedule admin test# Display results of the last HTTP test.[DeviceA] display nqa result admin testNQA entry (admin admin, tag test) test results:Destination IP address: 10.2.2.2Send operation times: 1 Receive response times: 1Min/Max/Average round trip time: 64/64/64Square-Sum of round trip time: 4096Last succeeded probe time: 2011-01-22 10:12:47.9Extended results:Packet loss in test: 0%Failures due to timeout: 0Failures due to disconnect: 0Failures due to no connection: 0Failures due to sequence error: 0Failures due to internal error: 0Failures due to other errors:Packet(s) arrived late: 0# Display the history of HTTP tests.[DeviceA] display nqa history admin testNQA entry (admin admin, tag test) history record(s):Index Response Status Time1 64 Succeeded 2011-01-22 10:12:47.9UDP jitter test configuration exampleNetwork requirementsAs shown in Figure 47, configure NQA UDP jitter tests to test the delay jitter of packet transmissionbetween Device A and Device B.