161Agent IP:3.3.3.1Collector Information:ID IP Port Aging Size Description1 6343 0 14002 3.3.3.2 6543 N/A 1400 netserver3 6343 0 14004 6343 0 14005 6343 0 14006 6343 0 14007 6343 0 14008 6343 0 14009 6343 0 140010 6343 0 1400sFlow Port Information:Interface CID Interval(s) FID MaxHLen Rate Mode StatusEth1/0/1 2 120 2 128 4000 Random ActiveThe output shows that Ethernet 1/0/1 enabled with sFlow is active, the counter sampling interval is 120seconds, the Flow sampling interval is 4000, all of which indicate sFlow operates normally.Troubleshooting sFlow configurationSymptomThe remote sFlow collector cannot receive sFlow packets.Analysis• The sFlow collector has no IP address specified.• No interface is enabled with sFlow to sample data.• The IP address of the sFlow collector specified on the sFlow agent is different from that of the remotesFlow collector.• No IP address is configured for the Layer 3 interface on the device, or the IP address is configured,but the UDP packets with the IP address being the source cannot reach the sFlow collector.• The physical link between the device and the sFlow collector fails.Solution1. Check whether sFlow is correctly configured by displaying sFlow configuration with the displaysflow command.2. Check whether the correct IP address is configured for the device to communicate with the sFlowcollector.3. Check whether the physical link between the device and the sFlow collector is normal.