Operation Manual – GVRPH3C S9500 Series Routing Switches Chapter 1 GVRP Configuration1-3Note:z After an aggregation group is created, although the GVRP-related configuration ofthe port operating as the master port remains unchanged and is synchronized to theslave ports, GVRP is not enabled on the slave ports.z Although ports added to an existing aggregation group adopt the GVRPconfiguration of the aggregation group, GVRP are not enabled on them.z When the master port leaves an aggregation group, the GVRP-relatedconfigurations on both the aggregation group and the port remain unchanged.However, when a slave port leaves an aggregation group, the GVRP-relatedconfiguration on the port is removed.z The GVRP-related configuration of a port in an aggregation group is mapped to allthe other members in the aggregation group.z When you query the GVRP feature configured on any port in an aggregation group,the returned result is about the master port of the group.1.2 Configuring GVRPComplete the following tasks to configure GVRP:z Enabling/Disabling Global GVRPz Enabling/Disabling Port GVRPz Setting the GVRP Registration Typez Setting GARP Timers1.2.1 Enabling/Disabling Global GVRPYou can use the following commands to enable or disable global GVRP.Perform the following configuration in system view.To do… Use the command…Enable global GVRP gvrpDisable global GVRP undo gvrpBy default, global GVRP is disabled.1.2.2 Enabling/Disabling Port GVRPYou can use the following commands to enable or disable GVRP on a port.Perform the following configurations in Ethernet port view.
