Operation Manual – Configuration File ManagementH3C S9500 Series Routing Switches Chapter 1 Configuration File Management1-2system is called current-configuration. You can use the following commands to displaythe current-configuration and saved-configuration information of the switch.Perform the following configuration to display the configurations of the switch:To do… Use the command… RemarksDisplay thesaved-configurationinformation of the switchdisplay saved-configuration Available in anyviewDisplay thecurrent-configurationinformation of theEthernet switchdisplay current-configuration[ controller | interfaceinterface-type interface-number |configuration [ configuration ] ] [ |{ begin | exclude | include }regular-expression ]Available in anyviewDisplay the runningconfiguration of thecurrent viewdisplay this Available in anyviewNote:The configuration files are displayed in their corresponding saving formats.1.2.2 Saving the Current-ConfigurationYou can modify the current configuration of the switch through the command lineinterface (CLI). Use the save command to save the current-configuration in the FlashMemory, and the configurations will become the saved-configuration when the systemis powered on for the next time.Perform the following configuration to save the current-configuration:To do… Use the command… RemarksSave the current-configuration save [ file-name ] Available in user viewEven if the problems like reboot and power-off occur during the modification, theconfiguration file can still be saved to Flash memory.1.2.3 Erasing Configuration Files from Flash MemoryThe reset saved-configuration command can be used to erase configuration filesfrom Flash Memory. The system will use the default configuration parameters forinitialization when the switch is powered on for the next time.
