Operation Manual – ARPH3C S9500 Series Routing Switches Chapter 2 ARP Table Size Configuration2-3To do… Use the command… RemarksConfigure the maximumnumber of aggregationARP entries supported bya cardarpmax-aggregation-entrymax-aggnumThe maximum number ofaggregation ARP entriessupported by a card is 1Kby default.Configure the maximumnumber of ARP entriessupported by the switcharp enable size { 4 | 64 }The maximum number ofARP entries supported bythe whole switch is 4K bydefault.To remove the configurations, use the corresponding undo commands.Caution:z Restart the system to make the above configurations effective.z After the above configurations, do not change cards or slots before you restart thesystem. Otherwise, the configurations may fail to take effect.z After the above configurations, do not perform active/standby switchover before yourestart the system. Otherwise, the configurations will not take effect even if yourestart the system.2.3 Displaying ARP Table Size ConfigurationTo do… Use the command… RemarksDisplay the maximum numbersof current ARP entries andentries that will take effect afterthe switch restartsdisplay arp max-entry Available in anyview2.4 ARP Table Size Configuration ExampleI. Network requirementsA host is connected to an S9500 series routing switch. The model names of all thecards in the switch system are suffixed with C, CA, or CB.
