Operation Manual – MPLS VPLSH3C S9500 Series Routing Switches Chapter 1 VPLS Configuration1-44[PE1-vsi-vpn1] quit[PE1] interface Vlan-interface 100[PE1-Vlan-interface100] l2 binding vsi vpn1[PE1-vsi-vpn1]dis this#vsi vpn1 staticlabel-range 0encapsulation ethernetbroadcast-restrain 100cos 1pwsignal ldpvsi-id 1peer 20.0.0.2 vc-id 1 encapsulation vlan#return[PE1-vsi-vpn1]# Create another seven VPLS instances, which are similar to vpn1 and mapped to labelranges 1 through 7 respectively.2) PE2 can be configured to operate in load sharing mode or to operate with a singleVPLS service card based on the actual networking requirement. The configurationsteps are omitted here.Note:You can configure a redirection rule for each individual label range or configure aredirection rule for all label ranges. You can apply a redirection rule to different publicnetwork ports, but you cannot map the same label range to different VPLS servicecards.1.5 Troubleshooting VPLSI. Symptom 1PW is not in UP state.Solution:z The LSP tunnel over the public network is not set up for the two ends: verify thatthe route is available on both ends, you can successfully ping the loopbackinterface of the peer, and the LDP session is normal.z Expansion session is abnormal: verify that the commands used to configure theexpansion session are executed on both ends, and the configurations are all right.
