Operation Manual – RMONH3C S9500 Series Routing Switches Chapter 1 RMON Configuration1-2overall traffic of the segment connected to the managed network device port, the errorstatistics and performance statistics, thereby implementing the management (generallyremote management) over the network.1.2 Configuring RMONNote:Before configuring RMON, you must ensure that the SNMP agent is properlyconfigured. See SNMP Configuration in the System Volume for the SNMP agentconfiguration.The following sections describe the RMON configuration tasks.z Adding/Deleting an Entry to/from the Event Tablez Adding/Deleting an Entry to/from the Alarm Tablez Adding/Deleting an Entry to/from the Extended RMON Alarm Tablez Adding/Deleting an Entry to/from the History Control Tablez Adding/Deleting an Entry to/from the Statistics Table1.2.1 Adding/Deleting an Entry to/from the Event TableRMON event management defines the event ID and the handling of the event.You can handle the event in the following ways:z Keeping logsz Sending the trap messages to NMSz Keeping logs and sending the trap messages to NMSPerform the following configuration to add/delete an entry to/from the event table:To do… Use the command… RemarksAdd an entry to the eventtablermon event event-entry [ descriptionstring ] { log | trap trap-community |log-trap log-trapcommunity | none }[ owner rmon-station ]Available insystem viewDelete an entry from theevent table undo rmon event event-entry Available insystem view1.2.2 Adding/Deleting an Entry to/from the Alarm TableRMON alarm management can monitor the specified alarm variables such as thestatistics on a port. When a value of the monitored data exceeds the defined threshold,
