Operation Manual – MPLSH3C S9500 Series Routing Switches Chapter 2 MPLS Basic Capability Configuration2-2The following sections describe the optional configuration tasks for MPLS basiccapability:z Configuring the Topology-Driven LSP Setup Policyz Configuring an LSP Setup Policyz Configuring Static LSP2.2.1 Defining MPLS LSR IDBefore configuring any other MPLS command, it is necessary to configure LSR ID first.This ID is usually in IP address format and must be unique in the domain.Perform the following configuration in the system view to define/delete an MPLS LSRID:To do... Use the command...Define LSR ID mpls lsr-id ip-addressDelete LSR ID undo mpls lsr-idBy default, LSR ID is not defined.2.2.2 Enabling MPLS and Entering MPLS ViewPerform the following operations in system view to enable/disable MPLS:To do... Use the command...Enable MPLS globally and enter MPLS view (systemview)Enable MPLS on a VLAN interface (VLAN interface view)mplsDisable MPLS globally or on a VLAN interface (system orVLAN interface view) undo mplsBy default, MPLS is not enabled.2.2.3 Configuring the Topology-Driven LSP Setup PolicyPerform the following operations in MPLS view to configure the topology-driven LSPsetup policy:
