HAI OMNI LT Owner's Manual

Also see for OMNI LT: Owner's manual Installation

Contents

HAI OMNI LT Owner's Manual Manual pdf 44 page image

36You may enter a unit number to start displaying the status of that unit, or simply press the down arrow key to scroll through thelist of units. The status display is as shown under Control, except that now the arrow keys may be used to continue scrollingbetween units.Porch Light 00:24:19LAST COMMANDED ON ↓You can also check the state and (if any) the remaining time duration of any Unit.At this point, you may press the ' # ' key to control the unit as specified under Controlling Units or press ' # # ' to configure andHLC or UPB device.Note: Only HAI manufactured UPB™ devices (collectively referred to as HLC devices) can be configured using an OmniLTcontroller. Other UPB™ devices may be used, but cannot be configured using the OmniLT controller; they must be configuredusing a PC running the UPB™ UPStart configuration software.Configuring HLC DevicesHLC devices can be configured using an Omni console or OmniTouch touchscreen connected to the OmniLT controller. Whenconfiguring HLC devices, the following information is programmed into the HLC device:¾ Network ID (UPB Network ID configured in OmniLT controller)¾ Network Name (HAI Lighting)¾ Unit ID (Unit Number of respective unit)¾ Unit Name (which is the name description given to the respective unit in the OmniLT controller)¾ Room Name (using HLC, the name of the first unit in the respective group is used; otherwise the room number is used)¾ Links (every device in each room is programmed with 6 consecutive Links, starting with Link 1; for example, every devicein Room 1 is programmed with Links 1-6, Room 2 is programmed with links 7-12, etc.)¾ Other configuration informationWhen configuring HLC devices using an Omni console or OmniTouch touchscreen, each device (unit number) must first beassigned a name in the OmniLT controller. HAI recommends that you first configure your OmniLT controller (naming all of theHLC units) using the HAI PC Access Software, and then download the information to the OmniLT controller.Configuring HLC Devices using an Omni ConsoleTo configure HLC devices from an Omni console, use the Status menu. To enter the Status menu, from the top-level display orthe main menu, press the 6 (STATUS) key on the console keypad.STATUS1=CTRL 2=ZONE 3=SUN ↓Press 1 (CTRL) to view the current status of each unit and to configure the HLC device that is assigned for each unit. Theconsole will display:Porch LightSTATUS OFF ↓You may enter a unit number to display the selected unit, or simply press the down arrow key to scroll through the list of namedunits.When the desired unit is displayed, put the selected HLC device into Setup Mode (See - Setup Mode for HLC Devices), and thenpress the ' # ' key twice (i.e. # #). The display will provide you with step-by-step configuration status. When complete, thedisplay shows:CONFIGURE Porch LightCOMPLETEDOnce completed, press the ' # ' key to return to the Status display and select your next unit (device). Put the next selected HLCdevice into Setup Mode (See - Setup Mode for HLC Devices) and then press the ' # ' key twice to configure the selected device.