HAI OMNI LT Owner's Manual

Also see for OMNI LT: Owner's manual Installation

Contents

HAI OMNI LT Owner's Manual Manual pdf 78 page image

702. When the House Code is configured as UPB, RadioRA, or CentraLite, “House Code All On” does not affect the state of theinstalled devices; however, if this setup item is set to “Yes”, OmniLT will change the status of all units on that House Codeto “On” (even though it doesn’t explicitly send an All On command to those units). If the “House Code All On” setup item isset to “No”, OmniLT will not change the status of units on that House Code.Time ClocksThere are three time clocks in the system are used to conditionalize programs. They are used solely to define time periods duringthe week when certain programs should be enabled or disabled to execute.TIME CLOCK 1 ONTIME CLOCK 1 OFFSpecify the On and Off times for each Time Clock - See Set Up Codes.TIME CLOCK 1 ON TIME:12:00 AM MTWTFSS #=CHNG¦TIME CLOCK 1 OFF TIME-- NEVER #=CHNG¦For example, it may be desirable to conditionalize certain programs to execute only during a normal Monday - Friday 9:00 AM -5:00 PM work week.The default for Time Clock 1 ON is 12:00 AM MTWTFSS, and the default for Time Clock 1 OFF is Never, so that Time Clock 1is always Enabled.TIME CLOCK 2 ONTIME CLOCK 2 OFFTIME CLOCK 3 ONTIME CLOCK 3 OFFTime Clocks 2 and 3 is entered into the system and set for time and dates exactly like the settings for Time Clock 1.Latitude, Longitude, and Time ZoneThe system automatically calculates the time of sunrise and sunset each day. Sunrise/sunset can be specified as the time ascheduling command is executed, as an enable/disable time, or as a darkness condition on a scheduling command or event button.To enable the system to properly calculate sunrise and sunset times, you must enter your latitude, location north or south of theequator, longitude, location east or west of the Prime Meridian, and time zone.These items should be set to the proper values for the location where the OmniLT is installed. The latitude and longitude for aparticular location may be obtained from an almanac or map of the area. These values should be entered to the nearest degree.The value entered for the time zone is the number of hours difference between local standard time at the OmniLT location andGreenwich Mean Time. The following values should be used for the standard time zones in North America:ZONE NAME4 ATLANTIC5 EASTERN6 CENTRAL7 MOUNTAIN8 PACIFIC9 YUKON10 ALASKA-HAWAII11 BERING