Hach AMTAX sc User Manual

Also see for AMTAX sc: Manual

Contents

Hach AMTAX sc User Manual Manual pdf 14 page image

14Installation3.2 Unpack the instrumentCAUTIONPay attention to the weight (approximately 31 kg) of theinstrument. Do not try to carry the instrument withoutassistance. Use only suitable lifting tackle for transport.Open the shipping container while it is on its end and then slide theanalyzer out of the cardboard. The items supplied will varydepending on the order. Standard items supplied for a minimalconfiguration include:• AMTAX sc and user manual• Collecting tray• Initial set of reagent and cleaning solutions2 standard solutions and electrolyte / membrane caps• Fastening bracket and angle bracket• Accessories for tubing and flow-through variant• Plug set3.3 Mechanical installationSelect a suitable place to install the instrument. Plan themechanical installation before positioning posts or drilling holes.Refer to Figure 1, page 7, Figure 2, page 8 for instrumentdimensions.Make sure that the fastening has sufficient load bearing capacity(approximately 160 kg). The wall plugs must be selected andapproved to suit the properties of the wall.Plan cable and tubing routes to avoid sharp bends and trippinghazards.When connecting two analyzers (e. g. for measuring twoparameters with a FILTRAX or Ultrafiltration), plan where theinstruments are to be installed and consider the length of theheated drain tubing (2 m).3.3.1 Mount the instrumentThe AMTAX sc can be mounted in three different ways:• Wall Mount (section 3.3.1.1),• Rail Mount; refer to the instruction sheet supplied with theRail Mounting Hardware.• Stand Mount; refer to the instruction sheet supplied with theRail Mounting Hardware.3.3.1.1 Wall mountRefer to Figure 5, Figure 6 and following instructions to mount theanalyzer to a wall.1. Align and install the fastening bracket to the wall.2. Attach the angle bracket to the instrument using thesupplied screws.3. Slide the bottom of the enclosure onto the fastening bracket.