Harman Stove Company P35i Owner's Manual

Harman Stove Company P35i Owner's Manual Manual pdf 19 page image

19Save These Instructions 3-90-775 Pellets or Corn/Pellet Mixture OnlyP35i Fireplace InsertB. Installing the SurroundThe surround consists of three panels, the top andtwo sides. Follow these steps for installation:1. Remove the insert body from the mounting frame;2. Start your leveling bolts into the floor of the frameand adjust to slightly raise the height.(see nextsection) This will allow some clearance toassemble the surround.3. Prepare the side panels by removing three nutseach. The left side panel is the one with the controlboard opening. If mounting the control door, thehinge bracket will attach using the control panelmounting screws.4. Attach the side panels to the mounting frame byguiding the threaded studs through the holes inthe mounting frame. Slip the power cord groundwire terminal over the bottom stud on the left side.Install the nuts onto the studs, finger tighten only.5. Install the top panel, making sure to close the gapwith the side panels first. Tighten the nuts on thesplice brackets securely.6. Set the mounting frame into position in thefireplace opening. Be sure the surround panel israised slightly so that it is not supporting any of theweight of the mounting frame.7. When pleased with the alignment, tighten all of thenuts securely.8. There are two more holes in the splice brackets toalign the outer sides of the surround panel joints. Ifdesired, install the supplied black pop-rivets here.C. Routing the Power CordWhen choosing an electrical supply outlet, be surethe polarity is correct, and that the supplied voltage iswithin the range of 117 to 123 Volts. Surge protectionis also recommended to protect the control boardsoftware in the event of a surge or spike.Once the outlet location is decided, you'll need toinstall and route the power cord.At the bottom of each of the side surround panelsis a knockout for the cord retainer. Remove theappropriate knockout and feedthe loose wire end of the cordinto the hole. If your cord needsto exit from the right side, routethe cord up the side and overthe top of the mounting frameand back down the left side.Attach the ground wire ringterminal to the bottom studon the left, and use the twohooks on the top corners ofthe mounting frame to securethe cord. Slip the cord clamp onto the cord right infront of the opening in the side panel. Using a pliers,compress the cord clamp and push it into the hole.WARNINGROUTE POWER CORD AWAY FROM THE APPLIANCE.DO NOT RUN THE CORD UNDER OR IN FRONT OFTHE APPLIANCE.Surround SplicePlateControlMountBracketsControl doorand hingeThree nuts tosecure to theframe.