v Predictive Failure Alerts (PFA)v Remote system problem-analysis supportv Power and temperature monitoringv Hot-swap drive baysv Error codes and messagesv System error loggingv Upgradable BIOS, diagnostics, and Advanced System Management Processorcodev Automatic restart after a power failurev Parity checking on the PCI busesv CRC checking on the SCSI busesv Error checking and correcting (ECC) memoryv Redundant Ethernet capabilitiesv Light Path Diagnostics on the system boardv Vital Product Data (VPD) on system board, and SCSI backplaneServer controls and indicatorsThis section identifies the controls and indicators on the front and the back of yourserver.Front viewPower controlbuttonPower-onlight (green)Selectbutton/indicator(green)ResetbuttonSystem errorlight (amber)Diskette driveactivity light(green)Diskette ejectbuttonHard disk drivestatus light (amber)Hard disk driveactivity light (green)CD eject buttonCD activitylight (green)Power-control button: Press this button to manually turn the server on or off.Power-on light: This green LED lights and stays on when you turn on your serverand blinks when the server is in standby mode.Reset button: Press this button to reset the server and run the power-on self-test(POST). You might need to use a pen or the end of a straightened paper clip topress the button.Select button/indicator: Press this button to select the server in the C2T chain. Thegreen LED on this button lights when the monitor, keyboard, and mouse arelogically connected to this server.System-error light: This amber LED lights when a system error occurs. An LED onthe Light Path Diagnostic panel on the system board will also be on to furtherisolate the error.Diskette drive activity light: When this LED is on, it indicates that the diskettedrive is in use.6 Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment BuildingSystem Type 8674
