ASM Firmware Update Utility diskette menu choicesThe main menu options are as follows:v Hardware Status and Informationv Configuration Settingsv Update System Management firmwarev ExitUse the up-and-down arrow keys to highlight the options. Online help is availablefor each option by pressing F1 while the option is highlighted. General Help isavailable by pressing F1 from one of the Help windows. To select an option,highlight it and then press Enter.Hardware Status and InformationSelect Hardware Status and Information for information on the current state of theASM processor. When you finish viewing this information, press Esc to return tothe main menu.Configuration SettingsSelect Configuration Settings to view or change the configuration settings of theASM processor. Select this choice to configure the following settings:v Alert Settingsv Dial In/Out Settingsv General Settingsv Modem SettingsAlert Settings: Select this choice to enable or disable all critical, non-critical, andsystem alerts supported by the ASM processor.Use the arrow keys and the Tab key to move between the fields. Use the left andright arrow keys to enable or disable each of the alerts. When you finish, press F6to save and return to the main menu. To return to the main menu without saving,press Esc.Dial In/Out Settings: Select this choice to configure dial in and dial out settings.To use Dial In, use the Tab key or the arrow keys to move the cursor to UserProfile to Configure. Then, use the left and right arrow keys to select a UserProfile. When you have selected a User Profile, you can set the following values:v Login IDv Passwordv Dialback (enable or disable)v Number (used for dialback only)v Read Only Access (enable or disable)v Dial In (enable or disable)v Dial In Delay (minutes)When you finish, press F6 to save and return to the main menu. To return to themain menu without saving, press Esc.To use Dial Out, use the Tab key or the arrow keys to move the cursor to UserProfile to Configure. Then, use the left and right arrow keys to select a UserProfile. When you have selected a User Profile, you can set the following values:Configuration 37
