a. Touch the static-protective package containing the new microprocessor toany unpainted metal surface on the server/workstation; then, remove themicroprocessor from the package.b. Orient the microprocessor over the microprocessor connector as shown inthe illustration. Carefully press the microprocessor into the connector.Note: To avoid bending the pins on the microprocessor, do not use excessiveforce when pressing it into the connector.Rear of serverMicroprocessorMicroprocessorconnectorMicroprocessororientation indicatorMicroprocessor-release lever6. Push the microprocessor release lever down to lock the microprocessor intoplace.7. Install the heat sink on the microprocessor:a. Peel the plastic protective strip off the bottom of the heat sink. Make surethe square of thermal material is still on the bottom of the heat sink.b. Align and place the heat sink on top of the microprocessor.Note: Locate the slot in the channel of the heat sink. Orientate the heat sinkso the slot will be at the rear of the server/workstation.c. Align and place the clip over the heat sin; then, snap the clip into placeover the heat sink with the heat sink release lever in the up position.Note: If you remove the microprocessor later, remember to install theterminator card in the appropriate microprocessor connector.d. Press the heat sink release lever down into the locked position once the clipis in place.8. Replace the clear shield, then go to “Installing the cover” on page 93.Note: It is very important to replace the clear shield.9. Start the server/workstation and run the Configuration/Setup Utility program.Installing options 89
