Memory Settings from the Advanced Setup menu, use the arrow keys tohighlight the bank that you want to enable; then, use the arrow keys to selectEnable.v Error LogsSelect this choice to view or clear error logs.– Select POST Error Log to view the three most recent error codes andmessages that the system generated during POST.Select Clear error logs from the POST Error Log menu to clear the error log.– Select System Event/Error Log to view the system event/error log. Thesystem event/error log contains all the system error and warning messagesthat the system has generated. You can use the arrow keys to move betweenpages in the system event/error log.Select Clear error logs from the System Event/Error Log menu to clear theerror or event log.v Save SettingsSelect this choice to save your customized settings.v Restore SettingsSelect this choice to delete your changes and restore the previous settings.v Load Default SettingsSelect this choice to cancel your changes and restore the factory settings.v Exit SetupIf you have made any changes, the program will prompt you to save thechanges or exit without saving the changes.Using passwordsThe System Security choice appears only on the full Configuration/Setup Utilitymenu. After you select this choice, you can implement two levels of passwordprotection: power-on password and administrator password.Power-on passwordAfter you set a power-on password, you can enable the unattended-start mode.This locks the keyboard and mouse, but allows the system to start the operatingsystem. The keyboard and mouse remain locked until you enter the correctpassword.You can use any combination of up to seven characters (A–Z, a–z, 0–9 and blanks)for your power-on password. Keep a record of your password in a secure place. Ifyou forget the power-on password, you can regain access to theserver/workstation through one of the following methods:v If an administrator password is set, enter the administrator password at thepower-on prompt. Start the Configuration/Setup Utility program and change thepower-on password.v Change the position of the password override jumper as described in “Settingthe password override switch”.v Remove the battery and then install the battery.Setting the password override switch: The following illustration shows thelocation of the password override switch, switch 4 of switch block 1, on the systemboard.Configuration 31
