IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

Contents

Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller (continued)Error code (hex) Description0x02 Explanation: Bad node address (multicast address). Action: Make sure the locally administeredaddress is valid, if one is specified. The address can not be a multicast address.0x03 Explanation: Failed self-test. Action: Make sure a cable is attached to the Ethernet connector. Ifthe problem persists, call for service.0x0D Explanation: Could not allocate enough memory for transmit queues. Action:1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties -> Advanced.4. Lower the resource values that apply to the transmit queue.0x0E Explanation: Could not allocate enough memory for receive queue. Action:1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties -> Advanced.4. Lower the resource values that apply to the receive queue.0x0F Explanation: Could not allocate enough memory for other structures. Action:1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.2. Select your IBM Ethernet adapter from the list.3. Select Properties -> Advanced.4. Lower the value for the resource named in the message.0x10 Explanation: Did not find any Ethernet controllers. Action: Using the Configuration/Setuputility, make sure that Ethernet is enabled.0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID. Action:Using the Configuration/Setup utility, make sure that Ethernet is enabled.0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.Action: Using the Configuration/Setup utility, make sure that Ethernet is enabled.0x16 Explanation: Single adapter found but multiple instances tried to load. Action: Using theConfiguration/Setup utility, make sure that Ethernet is enabled, and that the slot containing theIBM Netfinity 10/100 Ethernet Adapter or the IBM 10/100 Etherjet PCI adapter is enabled.0x17 Explanation: Slot parameter not specified in the registry. Action: Remove the adapter driver andreinstall it. If the problem persists, call for service.All other4-characterhexadecimalcodesAction: Call for service.Ethernet teaming messages:Table 6. NDIS (Windows NT or Windows 2000) driver teaming messages for the Ethernet controllerEvent ID Type Description01 Error Explanation: Team Name and physical adapter name are the same. Thisis an invalid configuration. Action: Reconfigure the adapter team bydouble-clicking the PROSet icon in the control panel.02 Error Explanation: Unable to allocate required resources. Action: Free somememory resources and restart.03 Error Explanation: Unable to read required registry parameters. Action:Reconfigure the adapter team by double-clicking the PROSet icon in thecontrol panel.Diagnostics 21