Cover releaselever Screws4. Remove the expansion-slot cover from PCI slot 2. Store it in a safe place forfuture use.Attention: Expansion-slot covers must be installed in all vacant slots. Thismaintains the electronic emission characteristics of the server and ensuresproper cooling of server components.5. Remove the adapter from the static-protective package.Attention: Avoid touching the components and gold-edge connectors on theadapter.6. Install the adapter as follows:a. Carefully grasp the adapter by its top edge or upper corners, and align itwith PCI slot 2 on the system board.Note: You must install the Remote Supervisor Adapter in PCI slot 2.b. Press the adapter firmly into the PCI slot. Be sure it is firmly seated.Attention: When you install the adapter in the server, be sure that it iscompletely and correctly seated in the system-board connector before youapply power. Incomplete insertion might cause damage to the systemboard or the adapter. Note that power can also be provided to the adapterthrough the system management connector (for the location of thisconnector, see “Remote Supervisor Adapter components” on page 62).7. Connect the internal cables to the adapter. Note that the 20-pin ribbon cable(see “Inventory checklist” on page 60), which connects the systemmanagement connector on the Remote Supervisor Adapter to the systemboard at J57 (see “System board options connectors” on page 44), also suppliespower to the adapter.64 Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment BuildingSystem Type 8674
