Chapter 5. Installation 251major Revision= 2 2minor Revision = 32 32manufacturer ID = 2 2product ID= 77 77build Name= A3BT31B A3BT31BFirmware and the image have the same version and build name.Start to program flash? (Y/N) Y_Start programming…Writing to Address: 0x0007FF80……OK.Download to Flash OK.BMC initialization…OK.BMC Firmware and SDRs updated successfully!!!Please remove the disk from the drive and restart the systemD :\>System BIOSIn a x3950 M2 multinode partition, you can update the BIOS of all nodes from theprimary node. You are presented with a menu from which you can select: Update the BIOS on the current system. Update all nodes in a multinode x3950 M2 partition from the primary node.The BIOS update process involves a sequence of erasing the current flashimage, updating the new flash image, requesting confirmation of the serialnumber (SN) and model type for each node in consecutive order (from first nodeto last node).Preboot Diagnostics (DSA Preboot)This update is in the form of a bootable diskette. If you have the RSA IIconfigured and connected to your network, you can use the Remote Consolefeature with a remote diskette and boot each node from the diagnostics diskette.On x3950 M2 multinode complex, if you perform the update from the primarynode, then all other nodes are automatically updated as shown in Example 5-3.Example 5-3 Updating the DSA Preboot code on a two-node complexCommands:update - Update/Recover your embedded usb chiphelp - Display this help message.exit - Quit program.Note: This will reboot the system.
