454 IBM eX5 Implementation Guide9.2.3 Updating firmware using the IMMThrough the Integrated Management Module (IMM), you can apply the following updates: IMM UEFI Field Programmable Gate Array (FPGA) Preboot Dynamic System Analysis (pDAS)You can use the .exe or .sh file to make an update. For the UEFI update, you must power upand boot the server into the operating system or in the UEFI Menu.Update the firmware in this order:1. IMM2. UEFI3. FPGA4. pDSAUse the IMM to update firmware:1. Log in into the IMM web interface.2. Select Tasks Firmware Update, as shown in Figure 9-6.Figure 9-6 IMM menu3. Click Browse and select the update file.4. Click Update to start the update process. A progress indicator opens as the file istransferred to the temporary storage of the IMM.When the transfer is completed, click Continue to complete the update process. A progressindicator opens as the firmware is flashed. A confirmation page opens to verify that theupdate was successful.9.3 Advanced Management Module (AMM)The Advanced Management Module (AMM) is a hot-swap module that you use to configureand manage all installed BladeCenter components. The AMM provides system managementfunctions and keyboard/video/mouse (KVM) multiplexing for all blade servers in theBladeCenter unit that support KVM. It controls a serial port for remote connection, theexternal keyboard, mouse, and video connections for use by a local console, and a 10/100Mbps Ethernet remote management connection.IMM firmware update: After the IMM firmware update, the IMM will be reset. The restart ofthe IMM after the update can take up to 9 minutes (13 minutes on a scalable complexsystem). After this restart, the IMM is ready for any further firmware updates.TasksPower/RestartRemote ControlPXE Network BootFirmware Update