Chapter 9. Management 479For the purposes of this exercise, we demonstrate how to install a platform agent on an HX5blade running Windows Server 2008. The method of deploying a platform agent to a Linux orWMware ESX server is the same.Complete these steps to discover and deploy a platform agent to an HX5 complex:1. Install Windows Server 2008 on the HX5 complex. We recommend using the IBMServerGuide, because it installs all necessary drivers as part of the process. You candownload the ServerGuide CD at the following website:http://ibm.com/support/entry/portal/docdisplay?lndocid=SERV-GUIDE2. Ensure that you have configured the complex correctly by accessing the AMM andnavigating to Scalable Complex Configuration.3. On the Scalable Complex Information window, click the Complex tab that contains thescalable systems. The numbers in parentheses on the tabs refer to the slots that containthe blades, as shown in Figure 9-31.Figure 9-31 Selecting an HX5 complex to partition4. Ensure that the Mode column status for the respective complex indicates Partition, asshown in Figure 9-31. If it does not indicate the Partition mode, see 8.6, “Creating an HX5scalable complex” on page 402.5. Complete the instructions in “Discovering a 2-node HX5 via IBM Systems Director 6.2.x” ifyou have not done so already.6. You are still logged in to the IBM Systems Director web console at this point. Discover theIP address of the operating system running on the primary HX5 node by navigating toInventory System Discovery.Discovery tip: To correctly discover and manage a complex via IBM Systems Director,you must discover the system both out-of-band via the IMM and in-band via the operatingsystem. A V6.2.1 or greater common or platform agent must also be installed.
