IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 14 page image

Section: 3IDS X64 User Manual 700-398-01D Issued August 201014[#] – This key is used to clear data that is incorrect. It can also be used to exit a programmingoption.[F] – This key is used if there is a fire emergency. If programmed to do so, the fire reporting codewill be sent to your monitoring company.[M] - This key is used if there is a medical emergency. If programmed to do so, the medicalreporting code will be sent to your monitoring company.[P] - This key is used if there is an emergency situation that requires emergency personnel torespond. A panic alarm will be transmitted to your monitoring company.Keys marked 1 through 9, and including 0, are used to input data into the programming options.4. The Keypad Buzzer[#] WITH any key from [0] to [6] for 1 secondThe keypad includes a buzzer that is used for audible signalling and verification of certain keypadfunctions. There are 7 possible volume settings: loud being the default setting. To program the keypadvolume, use Table 4:Table 4: Keypad Buzzer SettingsKey Entry Keypad Buzzer SSound Key Entry Keypad Buzzer TTone[#] [3] Loud (Default setting) [#] [6] 2kHz (High)[#] [2] Medium [#] [5] 1kHz (Medium)[#] [1] Soft [#] [4] 440Hz (Low)[#] [0] ClickTo change the volume (for this example to the “soft” setting) press the [#] and [1] keys simultaneouslyfor 1 second (long press). After a 1-second time lapse, the keypad will respond with a beep at the newvolume setting. This is a keypad specific setting, and applies to the keypad that this operation isperformed on.All zones programmed as Chime or Buzz zones, will sound with a loud buzz regardless of the keypadvolume set above.5. Arming the Control Panel5.1 Away Arm[#] [USER CODE](Leave via Entry/Exit zone)1. Ensure that the READY LED is on. If not, check that all protected doors and windows are closedand that all movement has ceased in areas covered by motion detectors. If necessary, close thefront door.2. Press the [#] key.3. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad buzzer will beep threetimes. In the event of an error press the [#] key and re-enter the code.