IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 16 page image

Section: 5IDS X64 User Manual 700-398-01D Issued August 2010165. The READY LED turns off, and the ARM LED will come on and the keypad buzzer will sound forthe duration of the exit delay.6. DO NOT violate the Entry/Exit zone (normally the front door). If the Entry/Exit zone is violated thesystem will arm in the AWAY mode.7. Upon expiry of the exit delay, the READY LED will remain off.8. Any STAY zones will be automatically bypassed (indicated by a steadily on LED).9. Ensure that you enter only those areas that are bypassed.10.5.4 Quick Stay ArmHold down the [5] key until the beepIt is possible to STAY arm by holding down the [5] key until the keypad buzzer sounds. The panel willimmediately arm into the stay mode without any exit delay. All stay zones will be bypassed.NOTE:Holding the button down again will cause the panel to toggle between stay profiles. This STAY profilethen becomes the active profile and the panel will STAY arm using this profile - until you elect to switchprofiles again.(See How to Select a Stay Profile, under section 13.1)5.4.1 How to Stay Arm and GoHold down the [6] key until the beepThis is a single key arm function that allows the user to STAY arm and leave the premises. If a partition isalready stay armed, holding down the [6] key initiates an exit delay, thus allowing the user to leave thepremises without disarming. At the end of the exit delay, the partition will re-arm in the same stay profile itwas armed in before the [6] key was held down.1. Hold down the [6] key until the keypad buzzer sounds. The keypad buzzer will sound for theduration of the exit delay. Only leave via a designated exit route.2. The READY LED will turn off and the ARM LED will come on.All stay zones will be bypassed.NOTE:Holding down the [6] key until the keypad buzzer sounds also ensures an entry delay on entering thepremises.EXAMPLE:Use this function when you leave your house, but the rest of your family is still at home sleeping.5.5 Key-switch or Remote Arming (If Fitted)1. Ensure that the READY LED is on before leaving.2. Leave the premises and lock the door.3. Activate the remote or the key-switch. (A remote can be used to Away Arm.) The panel will arm inthe away mode.