IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 19 page image

Section: 8IDS X64 User Manual 700-398-01D Issued August 2010 198.2 PanicHold down the [P] key until the beep¾ If the [P] key is pressed until the keypad beeps (approximately 1 second) a PANIC ALARMcondition will be activated.¾ The POWER LED stays on and the ARM LED flashes.¾ A PANIC ALARM may also be activated using any FIXED PANIC button or a REMOTE PANICbutton (if installed).¾ If the audible panic option has been selected, the siren will sound. A PANIC ALARM will betransmitted to the monitoring company.¾ To silence the siren, enter a valid [USER CODE].¾ Press the [P] key only in an emergency situation that requires response by emergencypersonnel.8.3 Medical AlarmsHold down the [M] key until the beep¾ If the [M] key is pressed until the keypad beeps (approximately 1 second) a MEDICAL ALARMcondition will be activated.¾ The keypad buzzer will beep 5 times.¾ A medical reporting code will be reported to the monitoring company.8.4 Duress Alarms[#] [DURESS CODE]¾ This is a special user code that should only be used in the unique situation where an intruderforces one to disarm the system “under duress”.¾ When a [DURESS CODE] is entered, the control panel disarms.¾ A Duress Alarm Code (if programmed) will be reported to the monitoring company.¾ It is advisable to choose a Duress code that can be easily remembered by all family (or staff)members.9. Alarm MemoryHold down the [0] key until the beepThe Alarm Memory displays any zones that were violated, tampered with, or bypassed during the lastarm cycle. A flashing ARM LED notifies the user of an alarm memory condition. To view the alarmmemory, disarm the panel and continue as follows:1. Hold down the [0] key until the keypad buzzer sounds.2. The POWER LED will turn off and the keypad buzzer will sound briefly.3. Zone LEDs that are on show which zones were violated during the last armed period.4. Press the [1] key followed by the [*] key to return to violated zones.5. Press the [2] key followed by the [*] key to display zones that were bypassed.