IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 35 page image

Section: 16IDS X64 User Manual 700-398-01D Issued August 2010 35Table 14: Trouble ConditionsZone LLED Trouble Condition1 Panel AC Supply Failure2 Panel Communications Failure3 Telephone Line Trouble4 Siren Tamper5 Low Battery6 Aux 12V Resettable Fuse Blown7 Engineer reset8 Box tamper9 Peripheral Device Tamper10 Peripheral Communications Failure11 Peripheral Low Supply Voltage12 EEPROM chip failure16.1 Explanation of Trouble Conditions16.1.1 Panel AC Supply FailureThis occurs when your Alarm Panel does not receive any power from your mains electricity. Causes ofthis can be a power failure, or your transformer is not plugged in or faulty. Your alarm company might notreceive your panic or alarm signal. Make sure to test your system.This trouble condition will only clear once the power has been restored.16.1.2 Panel Communications FailureThis occurs when communication to your monitoring company is not successful.The event will clear upon exiting the trouble viewing mode. If the event is a regular occurrence contactyour installer.16.1.3 Telephone Line TroubleThe causes of this could be a fault, or short, on your phone line; or your phone line could be cut.Contact your installer. This trouble condition will only clear once the phone line restored.16.1.4 Siren TamperThis can occur when the siren has been removed from circuit or the siren fuse on the panel has blown.Your siren will not sound and you or your neighbours will not be alerted if the alarm is violated.Contact your installer. This trouble condition will only clear once the siren has been put back into circuit orthe fuse has been replaced.16.1.5 Low BatteryThis trouble condition can be caused by a low battery voltage, a dead battery, or no battery. If the batteryis there, try charging it. If this not does work, then you may have to buy a new battery. A battery is an