IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 22 page image

Section: 10IDS X64 User Manual 700-398-01D Issued August 20102210.3 System Time and Date optionsRefer to Table 7 for system options. This is where you can change the time and date settings.Table 7: System Programming OptionsOptions Summary of Programmable OptionssOption 40 Allows for the editing of the time.Option 41 Allows for the editing of the date.11. User Program Mode1. Ensure that the panel is not armed.2. Hold down the [*] key until the keypad buzzer sounds.3. The ARM and READY LEDs will alternate flashing.4. Enter a [MASTER USER CODE]. The factory default is 1234. Should the [MASTER USERCODE] be defaulted to 6 digits, it will be 123456. Press the [*] key. A valid entry will beconfirmed by a long beep.5. If steps 1 to 4 are performed correctly, the READY LED will flash. If an invalid code was entered,the keypad buzzer will give an error beep. (3 short beeps). If the error beep occurs, press the [#]key (this clears all previous entries) and repeat steps 2-4.6. Select a programmable option from Table 5.EXAMPLE:To add a new user code, enter the User Program Mode by completing steps 1 - 4 as listed above.To access Option 0, enter a value of [0] (See Table 5) followed by the [*] key.Enter a [NEW USER CODE] followed by the [*] key. Once the user code is programmed, enter the nextcode followed by the [*] key. To exit user program mode press the [#] key.12. Explanation of Programmable Options12.1 Add a New User Code – Option 0Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [0] [*] [NEW USER CODE] [*]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [0] key followed by the [*] key to select the programmable option 0 (zero).3. The READY and ARM LEDs flash simultaneously.4. Enter the [NEW USER CODE] followed by the [*] key.5. The READY and ARM LEDs flash simultaneously.6. Further codes may be added by repeating step 4.7. Press the [#] key to exit the current option.8. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.