IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 23 page image

Section: 12IDS X64 User Manual 700-398-01D Issued August 2010 23NOTE:The new user code will be added to the first available slot. A slot is just a place holder number for a usercode. I.e. User code 1 is in slot 1; all the way to user code 128 is in slot 128.12.2 Edit a Selected User Code – Option 1Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [1] [*] [OLD CODE] [*] [NEW CODE] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [1] key followed by the [*] key to select programmable option 1.3. The READY and ARM LEDs flash simultaneously.4. Enter the [OLD CODE] which is to be edited followed by the [*] key.5. The READY and AWAY LEDs flash simultaneously, and the ARM LED will be on.6. Enter the [NEW CODE] followed by the [*] key.7. The READY and ARM LEDs flash simultaneously.8. To edit other codes repeat steps 4 - 7.9. Press the [#] key to exit the current option.10. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.12.3 Delete a User Code – Option 2 (Code Known)Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [2] [*] [USER CODE] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [2] key followed by the [*] key to select programmable option 2.3. The READY and ARM LEDs flash simultaneously.4. Enter the [USER CODE] to be deleted followed by the [*] key. “Deleting” the code in slot onewill reprogram it to 1234.5. The READY and ARM LEDs flash simultaneously.6. Further codes may be deleted by repeating step 4.7. Press the [#] key to exit the current option.8. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.12.4 Add/Edit Slot – Option 3Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [3] [*] [SLOT NUMBER] [*] [USER CODE] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [3] key followed by the [*] key to select Menu option 3.3. The READY and ARM LEDs flash simultaneously.4. Enter the [SLOT NUMBER] to be added/edited followed by the [*] key.5. The READY and AWAY LEDs flash simultaneously, and the ARM LED is on.6. Enter the [USER CODE] followed by the [*] key.7. The READY and ARM LEDs flash simultaneously.8. Further slots may be added/edited by repeating steps 4 - 7.