IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 31 page image

Section: 12IDS X64 User Manual 700-398-01D Issued August 2010 3112.15 Edit the Date - Option 41Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [4] [1] [*] [DATE] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [4] [1] keys followed by the [*] key to select programmable option 41.3. The READY and ARM LEDs flash simultaneously.4. Enter the [DATE] that you wish to edit.5. The date format is [DDMMYY].6. To confirm the entry press [*].7. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.13. Stay ZonesStay zones are those zones that are bypassed automatically when the system is “STAY ARMED”. Anyzone that should not trigger an alarm when violated in stay mode must be programmed as a stay zone.Stay zones need only be programmed once. Each time the system is armed in the Stay Mode the pre-selected stay zones will be bypassed automatically. The panel allows for 4 unique STAY PROFILES to bestored, consisting of a pre-selected combination of STAY and BUZZ zones, to suit a specific STAY ARMrequirement. STAY and BUZZ zones can be programmed for each profile only once the particular profilehas been selected. See section 13.2.NOTE:Stay arming with the [5] key does not change the current stay profile.However, if a partition is stay armed using Stay Profile 1, it is possible to toggle the panel directly to StayArm Profile two by holding the [5] key for two seconds until a beep is heard.EXAMPLE:¾ Stay Profile 1 – used for when the family has gone to bed, and only the bedroom zones arebypassed.¾ Stay Profile 2 – used for family time at home. All internal zones are bypassed; but the window,door, and outdoor zones are armed.¾ Stay Profile 3 – used for during the day when there is activity. In this instance, only the perimeterwill be armed.13.1 How to Select a Stay ProfileQuick Select Method (LCD only):Press the [5] key simultaneously with the [STAY PROFILE NUMBER] and release1. Ensure that the Panel is disarmed.2. Press the [#] key to clear any previous entries.3. Press the [5] key and then simultaneously press keys [1], [2], [3], or [4] – depending on thestay profile you want to choose – then release both keys.4. A beep will sound to indicate successful selection of a profile (an LCD keypad will also displaythe profile number).