IDS X64 User Manual

Also see for X64: Training manual User manual Installer manual Installer manual Manual

IDS X64 User Manual Manual pdf 30 page image

Section: 12IDS X64 User Manual 700-398-01D Issued August 2010307. The READY and AWAY LEDs flash simultaneously, and the ARM LED will be on.8. Repeat step 6 until you have selected all the modules that you want.9. Press the [#] key to exit the current option.10. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.Table 13: Specify which Telephone Module to useLED On / Off Action1 ON Telephone Module 2OFF Telephone Module 12 ON Telephone Module 2OFF Telephone Module 13 ON Telephone Module 2OFF Telephone Module 14 ON Telephone Module 2OFF Telephone Module 1NOTE:The options are only available if the corresponding option in Option 14 is on.EXAMPLE:If the close reporting code is disabled, then you will not be able to set the telephone module for it. If it isenabled, then you can choose between telephone module 1 and 2.12.12 Remote Receiver – Options 20 – 29 (Advanced)Refer to the X64 Remote Receiver Manual for the available user options that can be programmed.12.13 LCD Keypad – Option 30 (Advanced)Refer to the X64 LCD Keypad Manual for the available user option that can be programmed.12.14 Edit the Time - Option 40Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [4] [0] [*] [TIME] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 in section 11.2. Press the [4] [0] keys followed by the [*] key to select programmable option 40.3. The READY and ARM LEDs flash simultaneously.4. Enter the [TIME] that you wish to edit.5. The time format is 24 hours, [HHMM].6. To confirm the entry press [*].7. The READY LED flashes.8. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key againto exit user programming.