Programming after selectionq Select memory mode with [V/M].w Set the memory channel to be programmed with [DIAL].• Rotate [DIAL] while pushing [FUNC] to select a memory bank(A–H) or programmed scan edge channel.• Non-programmed channels cannot be selected.e Push [V/M] to select VFO mode.r Set the desired frequency:➥ Select the desired band with [↔].➥ Set the frequency using [DIAL].➥ Set other data (e.g. offset frequency, duplex direction,tone squelch frequency, etc.), if required.t Push [V/M] for 2 sec. to program the selected channel.• Keep pushing for 2 sec. or more to automatically select the nextmemory channel, if desired. Transferring memorycontents to another memoryq Select memory mode with [V/M].w Select the memory channel to transfer with [DIAL].• Rotate [DIAL] while pushing [FUNC] to select a memory bank(A–H) or programmed scan edge channel.e Push [V/M] for 1 sec. to indicate memory channels.• Do not hold [V/M] for more than 2 sec., otherwise the memorychannel contents will be transferred to VFO.r Rotate [DIAL] to select the channel to transfer to.• Rotate [DIAL] while pushing [FUNC] to select a memory bank orprogrammed scan edge channel.• VFO (VF), as well as regular memory channels, can be trans-ferred in this way.t Push [V/M] for 2 sec. to transfer.155MEMORY CHANNELSFM FMS1 3 5 7 9VOLFM146.340.000M:A03TS 15.0S1 3 5 7 9VOLFM146.340.000M: VFTS 15.0FMFUNCS1 3 5 7 9VOL. .M:A20TS .S1 3 5 7 9VOLFM146.340.000M:A20TS 15.0for1 sec.Select memorychannel for 2 sec.blankchannelV/M SKIPV/M SKIPV/M SKIPfor bankselection for CHselection+[EXAMPLE]: Transferring memory channel 3 (memory bank A) to 20 (memory bank A).