Icom IC-R10 Instruction Manual

Also see for IC-R10: Service manual Service manual

Contents

5 SCANNING OPERATION452. Program skip setting— cont.When BANK R becomes full, anerror beep sounds when trying toset more skip frequencies.When you want to cancel the skipfunction, turn OFF the SKIP settingin the memory channel (p. 56).t After set up, push [SCAN] or[CLR] to stop scanning.Stored frequencies are skipped dur-ing the next full, program or auto-memory write scan operation.1. Memory skip settingSet the skip condition in each mem-ory channel—refer to p. 55 MEM-ORY EDIT for details. Skip functionTwo skip functions are available as fol-lows:1. Program skip functionUsed with full, program and auto-mem-ory write scans, this function allows youto skip specified frequencies stored inBANK R (skip function must be ON forthese channels).2. Memory skip functionUsed with memory, BANK and modeselect scans, this function allows you toskip specified memory channels.These are activated when PROGRAMSKIP or MEMORY SKIP is turnedON in set mode (p. 59).Their factory pre-programmed settingsare:PROGRAM SKIP : OFFMEMORY SKIP : ON1. Program skip settingq Set PROGRAM SKIP to ON inset mode (p. 59).w Push [V/M] to select VFO mode.(p. 11)e Start full or program scan (p. 35).4While pushing[FUNC], push[ (V/M) MW] duringscan pause if youwant to skip thepaused frequency.Skip frequenciesare stored inBANK-R memorychannels (count-ing down fromchannel 99 to 00).PROGRAM SKIPON