Icom IC-R1500 Instruction Manual

Also see for IC-R1500: Service manual Instruction manual

62PANEL DESCRIPTION2y DSP INDICATOR ((p. 43))Appears when the DSP digital filter function is in use.• The DSP function requires an optional UT-106 installation.u FREQUENCY READOUTShows the operating frequency, channel names, set modecontents, etc.• Frequency decimal point blinks while scanning. ((p. 26))i MEMORY INDICATOR ((p. 16))Appears when memory mode is selected.o AUTO POWER-OFF INDICATOR ((p. 36))Appears while the auto power OFF function is in use.!0 PRIORITY INDICATOR ((p. 30))Appears while the priority watch is activated; blinks whilethe watch is paused.!1 MEMORY CHANNEL NUMBER INDICATORS➥ Shows the selected memory channel number. ((p. 16))➥ Shows the selected bank initial. ((p. 23))➥ “L” appears when the lock function is activated. ((p. 11))!2 SKIP INDICATORS ((p. 28))➥ “~” appears when the displayed memory channel isspecified as a skip channel.➥ “P~” appears when the displayed frequency is speci-fied as a program skip frequency.!3 VSC INDICATOR ((p. 13))Appears when the VSC function is in use.!4 TONE SQUELCH INDICATOR ((p. 33))Appears when the tone squelch function is in use.!5 POCKET BEEP INDICATOR ((p. 32))Appears with “ ” or “ ” while the pocket beep function(with CTCSS or DTCS) is in use.!6 DTCS SQUELCH INDICATOR ((p. 33))Appears while the DTCS squelch function is in use.!7 ATT INDICATOR ((p. 12))Appears when the ATT function is in use.!8 BUSY INDICATOR➥ Appears when a signal is being received or the squelchis open. ((p. 11))➥ Blinks while the monitor function is in use. ((p. 11))!9 S-METER INDICATORSShows the relative signal strength while receiving signals.((p. 11))