Icom IC-R1500 Instruction Manual

Also see for IC-R1500: Service manual Instruction manual

93 SETTING A FREQUENCY■ Tuning step selectionWhen using the tuning dial to change the frequency, or whena scan function is activated, the frequency changes in incre-ments determined by the set tuning step. This can bechanged if desired.The following tuning step are available.• 0.01 kHz (10 Hz) • 0.02 kHz (20 Hz) • 0.05 kHz (50 Hz)• 0.1 kHz (100 Hz) • 0.5 kHz (500 Hz) • 1 kHz• 2.5 kHz • 5 kHz • 6.25 kHz• 8.33 kHz • 9 kHz • 10 kHz• 12.5 kHz • 15 kHz • 20 kHz• 25 kHz • 30 kHz • 50 kHz• 100 kHz • 125 kHz • 150 kHz• 200 kHz • 500 kHz • 1000 kHz (1 MHz)q Push [V/MHz•SCAN] to select VFO mode, if necessary.w Push [TS•MODE] to enter tuning step select mode.e Rotate [DIAL] to select the desired tuning step.rPush any switch to exit tuning step select mode.■ Setting a frequencyq Rotate [DIAL] to set the frequency.• If VFO mode is not selected, push [V/MHz•SCAN] to select VFOmode.• The frequency changes in the selected tuning steps.wTo change the frequency band or in 1 MHz (10 MHz) steps,push [V/MHz•SCAN], then rotate [DIAL].• Pushing and holding [V/MHz•SCAN] for 1 sec. starts scan func-tion. If scan starts, push [V/MHz•SCAN] again to cancel it.While the band selection mode is selected,the digits below 100 kHz disappear.While 1 MHz tuning step isselected, the 1 MHz digitblinks.While 10 MHz tuning step isselected, the 10 MHz digitblinks.[DIAL][V/MHz•SCAN][DIAL][TS•MODE]