13Cooktop cartridges, either conventional coil or radiantelement, can be installed on either side of the range. (Seepage 33 for all available cartridges and accessories, and theirmodel numbers.)To Install Cartridges:1. If the grill grates, element, and/or basin pan are in place,remove before installing a cooktop cartridge. Cleanporcelain basin of any grease accumulation. (See page 8for cleaning recommendations.)2. To install any of the optional cooktop cartridges, be surecontrols are turned off and the cartridge is cool. Positionthe cartridge terminal plug toward the terminal receptacle.This receptacle is located at the front of the left side and atthe back of the right side of the range.3. Slide the cartridge toward the receptacle until thecartridge terminal plug is completely engaged.4. Lower the opposite end of the cartridge into the rangetopuntil it is flush with the surface. Your range is now readyto use.To Remove Cartridges:1. Controls must be off and the cartridge should be cool.2. Lift up the edge of the cartridge until top of cartridgeclears the opening on the range by about 2 inches.Important: Lifting the cartridge too high while stillengaged in the receptacle could damage the terminalplug.3. To disengage terminal, hold cartridge by the sides and pullaway from the terminal receptacle. Lift out when fullyunplugged.4. Do not stack cartridges where they may fall or bedamaged. Never store other materials on top of the glass-ceramic cartridges since this could damage or scratch thesurface.Home CanningCanning should be done on the conventional coil cartridgeonly. Canning element accessory, Model A145A, makes itpossible to use large oversized canners with the conventionalcoil cartridge.For additional information, refer to the Use and Care Guidepackaged with your cartridge.The grill accessory consists of two black grill grates, a grillelement and a basin pan. It may be installed on the left side ofthe cooktop only.To Install Grill:1. Before installing grill components, be certain controls areoff.2. Place the basin pan into the empty basin.3. Position the grill element with the terminal plug toward theterminal receptacle. This receptacle is located at the frontof the left side of the range. Slide the element toward thereceptacle until the terminal plug is completely engagedand supports rest on the sides of the basin.4. Place the grill grates on the top of the cooktop.To Remove Grill:1. Be sure controls are off. Remove grill components whenthey are cool.2. To remove grill element, pull away from receptacle until itis unplugged. Important: Lifting the element more than2 inches above the cooktop surface while it is engaged inthe receptacle could damage the terminal plug.Cooktop Cartridge Installation Grill Installation