546. Parameter Description6.1 US-ParametersPasswordWith different passwords different parameter groups can be accessedfor advanced programming.By entering a value of 1, all the LF parameters are returned to thefactory default values. Note the display will automatically changeto show the value of LF.99 upon successful loading of the defaultvalues.Adjustment value: 1 = reset all LF parametersDisplayed responses: PASS = default successfulbdPAS = default not successfulLF Parameter ResetBy entering a value of 1, the configuration file selected in LF.10 willbe loaded into the drive and all the LF parameters are returned to thefactory default values. Note this should be done before anyprogramming of the drive is carried out as all parameters will becleared. The display will change automatically to LF.99 uponsuccessful loading of the configuration. The process may take up to 3seconds.Adjustment value: 1 = Load ConfigurationDisplayed responses: Pro9 = Loading configurationPASS = Load successfulbdPAS = Load not successfulLoad ConfigurationThis parameter allows the user to select which mode the drive willoperate in. The possibilities are open loop induction motor, closedloop induction motor, closed loop permanent magnet motor, and lowspeed gearless modes. Select from the list below and then load theconfiguration file into the drive through parameter US.4.Adjustment value: IOPEn = Open loop inductionICLSd = Closed loop inductionI9LSS = Closed loop induction gearlessPCLSd = Closed loop permanent magnetP9LSS = Closed loop permanent magnetgearlessSelect ConfigurationParameter Description - Basic Set Up
