88Last ErrorDisplays the last 8 drive faults which occurred. The fault list can beviewed by changing the number to the left of the LF on the display. Thisnumber is the parameter offset number. Zero is the newest fault and 7is the oldest. See the adjustment steps below to view the fault mes-sages. A list of common faults, their causes, and trouble shooting tipsis located on the following pages.Error messages are always represented by an “E” and the correspond-ing error in the display of the TORQMAX. The inverter fault displays arelisted and described on the following pages. All faults are automati-cally reset up to an adjustable number of times. See parameter LF.5.Phase CurrentDisplay of the actual phase current.Resolution 0.1APeak Phase CurrentMaximum motor phase current that occurs during operation. Displayin [A]. The value can be deleted by pressing the UP or DOWN key.The memory is also deleted when the inverter is switched off.Display of the maximum dc-bus voltage measured. In addition thehighest value which occurs in ru.11 is stored in ru.12. (Erasing thepeak storage : see parameter ru. 8)Peak DC VoltageDisplay of the actual dc-bus voltageResolution: 1VActual DC VoltageDisplay of the actual output frequency.Resolution: 0.1 HzActual OutputFrequencyDiagnostic Parameters
