Kemppi AX MIG Welder Operating Manual

AX MIG WelderOperating manual - ENChanging settings1. Select the settings parameter for adjustment.2. Select the settings value.>> Depending on the settings parameter to be adjusted, refer also to the Device settings table below for moredetails.3. Confirm the new value / selection and close the adjustment view by selecting OK.Device settingsParameter Parameter value DescriptionWire feederSafe wire inch OFF/ONDefault = ONWhen ON, and the arc doesn't ignite, the filler wire is fed 5 cm.When OFF, 5 m of filler wire is fed.Wire retract OFF/AUTODefault = OFFThis is an automatic wire retract feature. Once the arc is extin-guished, the wire is retracted for additional safety. The user canchange the wire retract delay and length settings.- Retract delay 2...10 s, step 1Default = 5 s- Retract length 1...10 cm, step 1Default = 2 cmUser interfaceLanguage Available languagesWeld data time 1 ... 30 s0 = OFFDefault = 5 sThis defines if and how long the weld data summary is shownafter each weld.© Kemppi 124 1921900 / 2318