Kemppi AX MIG Welder Operating Manual

AX MIG WelderOperating manual - EN2.2 Connecting to AX Manager user interfaceThis section describes how to connect to the AX Manager user interface for the first time (or after a factory reset) withthe default network settings.The RCM serial number and security code can be found in the serial number sticker on the RCM device.WLAN access point mode (RCM+ only)1. Establish a wireless connection to AX Manager with your PC / tablet / mobile device.>> The WLAN default name (SSID) is AX<RCM serial number>, e.g., AX1234567.>> The default password is KemppiAX<RCM security code>, e.g.,KemppiAX1234.2. Once connected (connecting may take a few seconds), open an internet browser and enter the default networkaddress AX<RCM serial number>.local.>> The web address for RCM is AX<RCM serial number>.local, e.g., AX1234567.local.>> You are now connected to AX Manager.If the network address AX.local does not work, use the numeric IP address (192.168.3.1.).Ethernet port 1, DHCP server mode1. Connect your PC to the Ethernet port 1 (*) on the rear of RCM.2. Open an internet browser and enter the default network address AX<RCM serial number>.local.>> You are now connected to AX Manager.If the network address AX.local does not work, use the numeric IP address (192.168.2.1.).Tip: You can also connect to RCM via the Ethernet port 2 inside RCM (DHCP client mode). Using the Ethernetport 2 depends on the user's network and settings and requires knowing the RCM's LAN address received fromthe network or assigned statically.© Kemppi 23 1921900 / 2318