Kenwood KDC-W7031 Instruction Manual

Contents

English | 13Adjustment Item Display RangeFront High Pass Filter*2 "HPF-F Fc" Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter* 2 "HPF-R Fc" Through/40/60/80/100/120/150/180/220 HzLow Pass Filter*1,2 "LPF-SW" 50/60/80/100/120/Through HzSubwoofer Phase* 1,2 "SW Phase" Reverse (180°)/ Normal (0°)Volume offset "Vol-Offset" –8 — 0Loudness "LOUD" OFF/ONDual Zone System "2 ZONE" OFF/ON• Volume offset: Each source’s volume can be set as adifference from the basic volume.• Loudness: Compensating for low and high tonesduring low volume.• *1You can control this item when (page 36) is set to "SWPRE Sub-W". (KDC-W7031 only)• *1 You can control this item when Output> (page 13) is set to "SW ON".• *2 You can control this item when "2 ZONE" of Setup> is set to "OFF".• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- The channel of sub source is set up by System Setting> (page 38).- Main source is selected by [SRC] button.- The volume of Front channel is adjusted by [VOL]knob.- The volume of Rear channel is adjusted by Control> (page 12).- The Audio Control has no effect on sub source.• The Dual Zone System can be used with the Auxiliaryinput sources shown below.- Internal auxiliary input (KDC-W8531/W7531 only)- Option CA-C1AX (KDC-W7031 only)5 Exit Audio Setup modePress [VOL] knob for at least 1 second.Equalizer Control1 Select the source for adjustmentPress the [SRC] button.2 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "SYS.Q" isdisplayed above the [1] button.Refer to (page 9).3 Enter Equalizer Control modePress the [1] ("SYS.Q") button.4 Select the Equalizer Control item foradjustmentPress the [1] ("SYS.Q") button.5 Adjust the Equalizer control itemPush the Control knob to [4] or [¢].Each time the knob is pushed, the settingswitches as shown below.Sound setting DisplayUser memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP 40"Jazz "JAZZ"Natural "NATURAL"• User memory:The values set on the

• Each setting value is changed with the Setting> (page 11).First, select the speaker type with the Speaker setting.Subwoofer OutputTurning the Subwoofer output ON or OFF.Hold down on [AM] of the Control knob for atleast 1 second.Each time the button is pressed, Subwooferoutput switches ON and OFF.When it’s ON, "SW ON" is displayed.• You can control this item when (page 36) is set to "SWPRE Sub-W". (KDC-W7031 only)• You can control this item when "2 ZONE" of Setup> (page 12) is set to "OFF".