14 | EnglishGeneral featuresDisplay Mode SwitchingSwitching the display mode.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [2] button.Refer to (page 9).2 Enter display control modePress the [2] ("DISP") button.3 Select the display modePress the [1] ("MODE") button.4 Select the display TypePush the Control knob to [4] or [¢].Each time the knob is pushed, the display modeswitches as shown below.Display Mode Display"Display Type A" 1"Display Type B" 1 2"Display Type C" 433 53 6"Display Type D" 4 768 8 8 8 8 8"Display Type E"* 91 Graphic display part2 Text display part3 Text icon display part4 Upper text display part5 Middle text display part6 Lower text display part7 Source icon display part8 Function item display9 G-Analyzer display part• * Function of the KDC-W70315 Exit display control modePress the [6] ("RTN") button.• Under the display type other than "Display Type D",the function item is not displayed. When the displaytype other than "Display Type D" is selected, press [1]to [6] buttons or [NEXT] button. The function item willbe displayed approximately 5 seconds.• The information can be switched by the DisplayType. Refer to the page on the following table for themethods to switch by the Display Type.Display Type A B C D EGraphic 1 14 14 — — —Text 2 — 16 — — —Upper 4 — — 17 17 —Middle 5 — — 17 — —Lower 6 — — 17 17 —G-Analyzer 9 — — — — 20Display Type A/ Display Type BGraphic part/ Spectrum AnalyzerDisplay SwitchingSwitching the graphic Display/ Spectrum analyzerdisplay.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [2] button.Refer to (page 9).2 Enter display control modePress the [2] ("DISP") button.3 Select the display modePress the [1] ("MODE") button.4 Select the display TypePush the Control knob to [4] or [¢].Select the "Display Type A"/ "Display Type B"display.
