Kenwood KDC-W7031 Instruction Manual

Contents

38 | EnglishMenu systemFunction of the KDC-W7031G-Analyzer Stop WatchThe control of stop watch can be started by G-Analyzer function.• Do not use G-Analyzer stop watch on the Public roads.1 Select G-Analyzer Stop Watch modePush the Control knob to [FM] or [AM].Select the "Stop Watch" display.2 Enter G-Analyzer Stop Watch modePress the Control knob for at least 1 second."Stop" is displayed.3 Enter Counter Ready modePress the Control knob."Ready" is displayed.4 Start CountWhen G on the vertical direction is detectedduring the traveling, the count is automaticallystarted."Running" is displayed.• You can also start the counter by pressing the Controlknob.5 Stop CountPress the Control knob."Stop" is displayed.• The control will be started again when you accelerateor press the Control knob.Do the operation after step3.When you Reset the Count(While "Stop" is displayed)Press the Control knob for at least 2 seconds.• The reset of count can be done when the count isstopped.6 Exit G-Analyzer Stop Watch modePress the [MENU] button.• When "Running" is displayed (counted), the count iscontinued on although G-Analyzer Stop Watch modeis finished. If you want to stop the count, enter themenu mode then press the control knob.• When Power off (ex; ACC OFF) while counting, thevalue of 1 second or less will be "00".Other than Standby mode/When the Dual Zone System is ONDual Zone System SettingSetting the Front channel and Rear channelsound in the Dual Zone System.Display Setting"Zone 2 : Rear" Sub source (Auxiliary input source) is to be rearchannel."Zone 2 : Front" Sub source (Auxiliary input source) is to be frontchannel.Other than Standby modeB.M.S. (Bass Management System)Adjust the bass boost level of the externalamplifier using the main unit.Display Setting"AMP Bass : Flat" Bass boost level is flat."AMP Bass : +6" Bass boost level is low (+6dB)."AMP Bass : +12" Bass boost level is mid (+12dB)."AMP Bass : +18" Bass boost level is high (+18dB).• Refer to the catalog or instruction manual for poweramplifiers that can be controlled from this unit.• For amplifiers there are the model that can be setfrom Flat to +18 dB, and the model that can be setfrom Flat to +12 dB.When an amplifier that can only be set to +12 isconnected to the unit, "AMP Bass : +18" won’t workcorrectly even if it’s selected.Other than Standby modeB.M.S. Frequency OffsetSetting the central frequency boosted by B.M.S.Display Setting"AMP FREQ : Normal" Boost with the normal central frequency."AMP FREQ : Low" Drop the normal central frequency 20%.