Kenwood TM-D710A (K type) Instruction Manual

Also see for RC-D710: Instruction manual Instruction manual Brochure Brochure

Contents

EchoLink-2■ Selecting a Transmit SpeedSome repeaters may not respond correctly if a code istransmitted at fast speed. If this happens, change theEchoLink transmission speed from FAST (default) toSLOW.1 Enter Menu mode and access Menu 205.2 Set the speed to FAST or SLOW.SETTING UP EchoLink Sysop MODEConnect the TM-D710 to a personal computer to use thesystem as a node station for EchoLink relaying.When connecting to a personal computer and using theEchoLink Sysop mode, the hard flow control operationRTS and CTS computer terminals operate the same asand are changed with the SQC (squelch control signaloutput to the computer) and PKS (transmit control signalinput from the computer) data terminals.The current band becomes the same as the data bandwhich is selected in menu No. 517, regardless of thetransmission band and operation band.Use the PG-5H (interface cable kit) when connecting to apersonal computer.1 Turn the transceiver power OFF.2 Press [PF2] + Power ON to turn EchoLink SysopMode ON.• The icon appears on the display when EchoLink Sysopmode is ON.• When the audio signal is output to the PC side, theicon blinks.• To turn EchoLink Sysop Mode OFF, press [PF2] + PowerON again.EchoLink Sysop Mode ON EchoLink Sysop Mode OFFPCterminal PC PCterminal PCTxD g RxD TxD g RxDRxD f TxD RxD f TxDSQC g CTS RTS g CTSPKS f RTS CTS f RTSGND n GND GND n GNDData communications cableSerial communications cableTo PC audio terminalPink: To microphone input terminalGreen: To line out terminalTo PC 9-pin D-SUBterminal