Kenwood TM-D710A (K type) Instruction Manual

Also see for RC-D710: Instruction manual Instruction manual Brochure Brochure

Contents

OTHER OP-2KEY BEEPYou can turn the transceiver beep function ON or OFF asdesired.1 Enter Menu mode and access Menu 000.2 Turn the beep function ON or OFF.• Even with the beep function turned OFF, the transceiverwill emit a beep tone under the following conditions:1) When Auto Power Off is activated, the transceiver willbeep 1 minute before the power turns off.2) After transmitting for the maximum time durationaccording to the Time-out Timer, the transceiver willbeep■ Beep VolumeEach time you press a key, the beep tone will sound.If you have left the beep function turned ON, you maywish to adjust the volume level of the beep.1 Enter Menu mode and access Menu 001.2 Set the beep volume to a level from 1 to 7.• The default is level 5.EXTERNAL SPEAKER CONFIGURATIONThis transceiver has two speaker jacks for externalspeakers, as well as an internal speaker. You can enjoya variety of speaker configurations by using one or twoexternal speakers. Received signals on bands A and Bare output depending on how you want the internal and/orexternal speakers to function.1 Enter Menu mode and access Menu 002.2 Set the speaker mode to MODE 1 or MODE 2.• Refer to the table below for configurations based on themode selected.Mode SpeakerSetupBand OutputInternalSpeakerExternalSP1ExternalSP2MODE 1None A, B – –SP1 only x A, B –SP2 only A – BSP1, SP2 x A BMODE 2None A, B – –SP1 only x A, B –SP2 only B – ASP1, SP2 x B APROGRAMMABLE VFOIf you always check frequencies within a certain range,you can set upper and lower limits for frequencies that areselectable. For example, if you select 144 MHz for thelower limit and 145 MHz for the upper limit, the tunablerange will be from 144.000 MHz to 145.995 MHz.1 Select your desired VFO frequency.2 Enter Menu mode and access Menu 100.(Example: E type)3 Press the Tuning control.• The lower frequency limit blinks.4 Rotate the Tuning control to select your desired lowerfrequency limit, then press the Tuning control to setthe selected value.• The upper frequency limit blinks.5 Rotate the Tuning control to select your desired upperfrequency limit, then press the Tuning control to setthe selected value.6 Press [ESC] to exit Menu mode.Note: You cannot program the 100 kHz and subsequent digits. Theexact 100 kHz and subsequent digits of the upper limit depend on thefrequency step size you are using.