83 ENAdditional InformationFirmware UpdateIMPORTANT: Be sure to update the KENWOOD PC SERVER sofware to the latest version before updating the Firmware. uThe latest information and procedure to update your KENWOOD PC SERVER software and VRS-N8100 Firmware can befound in the "Technical Support" / "Service" section on the website of your resident country (if necessary you can find alink to your local website on www.kenwood.com ).Exit from all software that is currentry running. Do not perform any other operations while performing the operations of steps 1 to 7,but perform the steps one after the other.1Turn on the power to this receiver by pressing the POWER ON/STANDBY (For U.S.A. and Canada) or the ON/STANDBY(For Europe and Australia) key (or the POWER RCVR key on theremote).2Use the INPUT SELECTOR key (or the Network Server key)to select “NET SERVER”.When the “NET SERVER” input is selected, the OSD function onthe TV screen is activated and detection of the server starts.SEARCHING3Use the MULTI CONTROL %/fi(or Multi %/fikeys) toselect the PC server to be logged in, and press ENTER (orthe Enter key).Please choose server.PC Server 7PC Server 1PC Server 2PC Server 3PC Server 4PC Server 5PC Server 64Use the MULTI CONTROL %/ fi/@/ #(or the Multi %/ fi/@/ #keys) to select “SETUP”, and press the ENTER (or theEnter key).Home displayMOVIEMUSICPHOTOLOG OFFSETUPE N T E RMovie Theater5Use the MULTI CONTROL %/ fi(or the Multi %/ fikeys) toselect “Network Setup”, and press the ENTER (or the Enterkey).Receiver SetupNetwork SetupExitNET LINK PC SERVER1 Setup Menu6Use the MULTI CONTROL %/ fi(or the Multi %/ fikeys) to select “Firmware Update” and press the ENTER(or the Enter key) to display the Update display.MainIPNET LINKMenu LanguageVideo OutScreen SaverBlack Level SetupFifmware UpdateBack BackNetwork Setup7Select “UPDATE” and press the ENTER (or the Enter key)to start the updating.This unit turns OFF automatically when the firmware updatingcompletes successfully.÷ During update, don't turn off this unit, PC and router, ordon't extract an Ethernet cable.÷ When the update has been completed, "UPDATE OK" isdisplayed.÷ If the update failed, "ERROR" is displayed on the screen.÷ The update may fail and stop operating due to possible PC,network environment or power failure during the updateprocess. In that case please remove the power cord fromwall socket immediately and consult your dealer.
