Makita DLS713 Instruction Manual

Also see for DLS713: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

miter angle

11 ENGLISHSub-fenceCountry specificCAUTION: When performing left bevel cuts,flip the sub-fence outward. Otherwise, it may con-tact the blade or a part of the tool, and may result inserious injury to the operator.1► 1. Sub-fenceThis tool is equipped with the sub-fence. Usually posi-tion the sub-fence inside. However, when performingleft bevel cuts, flip it outward.Adjusting the miter angle123 45► 1. Turn base 2. Lock lever 3. Miter scale 4. Pointer5. GripLoosen the grip by turning counterclockwise. Turn theturn base while pressing down the lock lever. When youhave moved the grip to the position where the pointerpoints to the desired angle on the miter scale, securelytighten the grip clockwise.CAUTION:• After changing the miter angle, always securethe turn base by tightening the grip firmly.NOTICE:• When turning the turn base, be sure to raise thehandle fully.Adjusting the bevel angle12► 1. Lever 2. Release button123► 1. Pointer 2. Bevel scale 3. ArmTo adjust the bevel angle, loosen the lever at the rear ofthe tool counterclockwise.Push the handle to the left to tilt the saw blade until thepointer points to the desired angle on the bevel scale.Then tighten the lever clockwise firmly to secure thearm.To tilt the blade to the right, push the release button atthe rear of the tool while tilting the blade slightly to theleft after loosening the lever. With the release buttondepressed, tilt the saw blade to the right.CAUTION:• After changing the bevel angle, always securethe arm by tightening the lever clockwise.NOTICE:• When tilting the saw blade be sure the handle isfully raised.• When changing bevel angles, be sure to positionthe kerf boards appropriately as explained in the"Positioning kerf boards" section.