15,QVSHFWLRQDQGUH¿OORIHQJLQHRLO- Perform the following procedure, with the engine cooled down.- Set the engine level, remove oil cap (Fig. 1), and check to see whether or not there is oil in the range between the upper limit and lower limitmarks of the oil pipe (Fig. 2).- 7RSXSZLWKRLOWRXSSHUOLPLWPDUNLIRLOLVLQVXI¿FLHQW RLOOHYHOLVFORVHWRORZHUOLPLWPDUN )LJ - The area surrounding the external marks is transparent, so the amount of oil inside can be checked without having to remove the oil cap.However, if oil pipe becomes extremely dirty, visibility may be lost, and oil level will have to be checked against stepped section on inside ofoil pipe.- )RUUHIHUHQFHWKHRLOUH¿OOWLPHLVDERXWK HYHU\UHIXHOOLQJV If the oil changes in color or mixes with dirt, replace it with new one. (For the interval and method of replacement, refer to P 20)Recommended oil:6$(:RLORI$3,&ODVVL¿FDWLRQ&ODVV6)RUKLJKHU VWURNHHQJLQHIRUDXWRPRELOHOil volume: Approx. 0.08L1RWH,IWKHHQJLQHLVQRWNHSWXSULJKWRLOPD\JRLQWRDURXQGWKHHQJLQHDQGPD\EHUH¿OOHGH[FHVVLYHO\,IWKHRLOLV¿OOHGDERYHWKHOLPLWWKHRLOPD\EHFRQWDPLQDWHGRUPD\FDWFK¿UHZLWKZKLWHVPRNHPoint 1 in Replacement of oil: “Oil cap”- 5HPRYHGXVWRUGLUWQHDUWKHRLOUH¿OOSRUWDQGGHWDFKWKHRLOFDS- Keep the detached oil cap free of sand or dust. Otherwise, any sand or dust adhering to the oil cap may cause irregular oil circulation orwear on the engine parts, which will result in troubles.Fig. 1 Fig. 2 Oil pipe Fig. 3BEFORE START OF OPERATION(1) Keep the engine level, and detach the oil cap.(2) Fill with oil to upper limit mark. (see Fig. 3) 8VHRLOERWWOHZKHQ¿OOLQJ 6HFXUHO\WLJKWHQWKHRLOFDS,QVXI¿FLHQWWLJKWHQLQJPD\FDXVHRLOOHDNDJHOil capOil pipeInternal steppedsection (upperlimit)External mark(lower limit)Internal steppedsection (lowerlimit)External mark(upper limit)OilTop up with oil untiloil level reachesinternal steppedsection (upperlimit). The area between theexternal upper and lowerlimits is transparent, sooil level can be checkedexternally against thesemarks.